ADC CUDA 3 - Manual (Page 247)

Cuda 12000 IP Access Switch CLI-based Administration Guide
Displaying DHCP Relay Configuration 245
■
MTA Gateway Address — The MTA Gateway address that the DHCP
Relay requests on behalf of the MTA device. This is the same address
as the Gateway Address configured on the interface.When a DHCP
Request is received and it is from the MTA device, then the MTA
Gateway Address is used by the DHCP Relay.
■
Enable or disable agent options.
Displaying DHCP Relay Configuration
You can display the current DHCP relay configuration using the show
dhcp-relay command from within interface cable <c/s/i> mode, as shown in
the following example:
cli:192.168.208.3:interface:cable:csi(1/1/1)# show dhcp-relay
dhcp-relay enable
Add Agent Options enable
Drop Mismatch disable
Max. Pkt. Len. 576
Relay Mode replace
Server Address
----------------
giAddresses:
CM 201.1.1.1
CPE 201.1.2.1
MTA 0.0.0.0
cli:192.168.208.3:interface:cable:csi(1/1/1)#