Sony SU-LW1 - Manual (Page 18)

18
(US)
3
1
2
3
4
6
Mount the display on the Plate
Unit.
1 To lock the arms temporarily, put the two
securing screws (+B5
× L12, supplied) in the
holes on the arm bases B from the outside.
2 Hang the upper hooks of the Mounting Hook
Units on the upper shafts of the arms.
3 Place the lower hooks of the Mounting Hook
Units on the lower shafts of the arms.
4 Pushing the display towards the Plate Unit,
lift it up slowly and hang the lower hooks of
the arms onto the lower shafts.
5 Check to make sure that all eight hooks are
properly hung on the corresponding shafts.
6 Tighten the securing screws attached in 1.
Note
If you push the securing screws into the holes
too far (1), the tips of the screws will get in the
way when you hang the lower hooks on the
shafts (4).
Do not push
the screws in
too far.