Sony SU-LW1 - Manual (Page 8)

8
(US)
Step 2: Adjust the position of the arm bases
(For the KLV-26HG2 only)
1
Step 3: Decide on the location for installation
1
If you are going to install a KDL32XBR950
or a KLV30XBR900, skip Step 2 and go to
Step 3.
1 Remove the four (two for each arm
bases) tilt adjusters .
2 Remove the four screws that secure the
arm bases to the Plate Unit.
3 Remove the arm bases A and put them
in the slots facing inward. Put both arms
and the arm bases B on the arm bases
A.
4 Secure the arm bases to the Plate Unit
using the four screws removed in 2.
5 Secure the arms to the arm bases using
the four tilt adjusters removed in 1.
Notes
• If you are installing a display other than
the KLV-26HG2, skip Step 2.
• When using an electric screwdriver to
tighten the screws, the torque must be
approx. 2 N
• m.
Leave spaces around the display. At
least the amount of space shown in
the diagram should be left between
the display and a ceiling or raised
portions of the wall.
Tip
Refer to the table (9 (US)) for the display installation
dimensions.
2
2
5
5
3
3
3
4
4
1
1
Arm
Arm base B
Arm base A
Tilt adjuster
Arm
Tilt adjuster Arm base A
Arm base B
Unit: mm (inches)
300
(11
13
/ 16
)
100
(3
15
⁄ 16
)
100
(3 15 ⁄
16
)
100
(3 15 ⁄
16
)
Arm base A
Arm base B
Arm base B
Arm base A