Sony CDP-CX400 - Manual (Page 17)

Playing CDs
17
Playing CDs
4
Push the JOG dial.
5
To program other discs/tracks, do the following:
To program
All tracks of another disc(s)
Other tracks on the same disc
Other tracks on other discs
6
Press H to start Program Play.
To cancel Program Play
Press CONTINUE.
z The programs remain even after Program Play ends
When you press H in Program Play mode, you can play
the same program again.
z When you press PROGRAM to select Program Play
during Continuous or Shuffle Play
The program is played after the current track.
z The program remains until erased
Even if you replace discs, the programmed disc and track
numbers remain. Therefore, the player will play the new
disc and track numbers. However, the programmed disc
and track numbers that are not found in the player or on
the disc are deleted from the program, and the rest of the
program is played in the programmed order.
z You can select the program number (PROGRAM 1,2,
or 3) by using the remote Z
Press PROGRAM on the remote repeatedly until the
desired program number appears in the display.
Note
If you select Group Play mode (on page 26), Artist Play mode
(on page 28), or Hit List (on page 29), Program Play will be
canceled.
The track
being programmed
S DISC ALL
NEXT
CD TEXT
1
CD2
GROUP
NO DELAY MULTI
2 3 X-FADE DELETE
CD3
REPEAT SHUFFLE 1
SEC STEP MIN ART. GROUP TRACK HIT ART. 2nd DISC
* D I S C - 2 * * 0 * * *
CD1
PROGRAM 1
Playing order
The disc being
programmed
Repeat Step(s)
2 and 4
3 and 4
2 to 4
Checking the programmed order
You can check your program before or after you start
playing.
Press CHECK.
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
“AL” appears instead of the track number.) After the
last step in the program, the display shows “– END –”
and returns to the original display.
Changing the programmed order
You can change your program before you start playing.
To
Erase a track or disc
Erase the last track or disc in
the program
Add tracks or discs to the end
of the program
Erase the whole program
completely
You need to
Press CHECK until the track
or disc you don’t want
appears in the display, then
press CLEAR.
Press CLEAR. Each time you
press the button, the last
programmed track or disc
will be cleared.
Follow the programming
procedure.
Hold down CLEAR until
“CLEAR” appears in the
display to erase the whole
program, then create a new
program following the
programming procedure.
Erasing the program stored in memory
1 Press PROGRAM repeatedly in stop mode until
the program number (PROGRAM 1, 2, or 3) you
want to erase appears in the display.
2
Press and hold CLEAR until “CLEAR” appears in
the display.