Sony MZ-RH1 User Manual

Page 66

Advertising
background image

Symptom

Case and/or corrective action

Recording cannot be done

correctly.

 Audio sources may not be securely connected. Disconnect the

audio sources once and connect them again ( pages 31, 37).

 There is no digital signal from the portable CD player. When

recording digitally from a portable CD player, use the AC power
adaptor and disable the anti-skip function (such as ESP) on the
CD player.

 The analog recording was made using a connecting cord with an

attenuator. Use a connecting cord without an attenuator ( page

11).

 Recording level is too small to record (when adjusting the

recording level manually). Pause the recorder and adjust the
recording level ( page 52).

 The recorder is connected to the computer. Disconnect the

recorder from the computer when recording.

 The power sources was disconnected or a power outage occurred

during recording. The recording result is not recorded on the disc.
Make recording again.

 Recording may not be done if the remaining recordable time on

the disc is 48 seconds or less (“DISC FULL” appears). Replace
the disc.

The lid does not open after

recording.

 The lid does not open until “SystemFILE WRITING” disappears

in the display.

“TRACK FULL” appears even

before the disc has reached the

maximum recording time and the

recording cannot be done.

 This occurs due to the limitation of the system. When 2,047 tracks

(on a disc used in Hi-MD mode) or 254 tracks (on a disc used
in MD mode) have been recorded on the disc, “TRACK FULL”
appears regardless of the total recorded time. More than 2,047
tracks or 254 tracks cannot be recorded on the disc. To continue
recording, erase unnecessary tracks.

The remaining recording time does

not increase even after erasing

numerous short tracks.

 This occurs due to the MiniDisc system limitation (in MD mode

only). Tracks of under 12 seconds (in SP mode), 24 seconds (in
LP2 mode or monaural), or 48 seconds (in LP4 mode) in length
are not counted and so erasing them may not lead to an increase in
the recording time.

66

MZ-RH1/MZ-M200.GB.2-669-084-11(1)

Advertising
This manual is related to the following products: