Sony MZ-RH1 - Manual (Page 78)

On moisture condensation
If the recorder is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense inside
or outside the recorder. Should this occur, the
recorder will not operate properly.
Moisture condensation occurs easily
when:
• The recorder is brought from a cold location
such as a ski slope into a warmly heated
room.
• The recorder is taken from an air-
conditioned room or car interior to the hot
outdoors, etc.
How to prevent moisture condensation
When bringing the recorder from a cold place
to a warm place, seal the recorder in a plastic
bag and allow it to adapt to conditions at the
new location over a period of time (about an
hour).
If moisture condensation occurs
Turn off the recorder and wait about an hour
for the moisture to evaporate. Make sure the
moisture has evaporated before using the
recorder.
Specification
Audio playing system
MiniDisc digital audio system
Systems
MiniDisc system, Hi-MD system
Laser diode properties
Emission duration: continuous
Laser output: less than 44.6 µW
(This output is the value measured at a distance of
200 mm from the lens surface on the optical pick-up
block with 7 mm aperture.)
Recording and playback time
See “List of the recording time for each disc”
( page 81)
Revolutions
Approx. 350 rpm to 3,600 rpm (CLV)
Error correction
Hi-MD:
LDC (Long Distance Code)/BIS (Burst Indicator
Subcode)
MD:
ACIRC (Advanced Cross Interleave Reed Solomon
Code)
Sampling frequency
44.1 kHz
Sampling rate converter
Optical (digital) input: 32 kHz/44.1 kHz/48 kHz
78
MZ-RH1/MZ-M200.GB.2-669-084-11(1)