Sony STR-DH800 - Manual (Page 32)

32 US
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
After “Clear All” appears on the display
for a while, “Press ENT” appears.
3
Press MEMORY/ENTER.
After “CLEARING” appears on the
display for a while, “CLEARED”
appears.
All the settings you have changed or
adjusted are reset to the initial settings.
Insert two R6 (size-AA) batteries in the
RM-AAP043 Remote Commander.
Observe the correct polarity when installing
batteries.
Notes
• Do not leave the remote in an extremely hot or
humid place.
• Do not use a new battery with old ones.
• Do not mix manganese batteries and other kinds of
batteries.
• Do not expose the remote sensor to direct sunlight
or lighting apparatuses. Doing so may cause a
malfunction.
• If you do not intend to use the remote for an
extended period of time, remove the batteries to
avoid possible damage from battery leakage and
corrosion.
• When you replace the batteries, the programmed
remote codes may be cleared. If this happens,
program the remote codes again (page 104).
• When the remote no longer operates the receiver,
replace all the batteries with new ones.
Performing initial setup
operations
?/1
PHONES
SPEAKERS
INPUT SELECTOR
INPUT MODE TUNING MODE
MASTER VOLUME
TONE MODE DISPLAY DIMMER MUTING MEMORY/ ENTER 2CH/ A.DIRECT A.F.D. MOVIE MUSIC TUNING
TONE
VIDEO 2 IN VIDEO L AUDIO R AUTO CAL MIC
?/1
MEMORY/ENTER
Inserting batteries into the
remote