Sony PCGA-UVC11A - Manual (Page 21)

21 GB
Continued on next page
Using the Camera
This section describes how to use the camera.
Notes
• When using the camera for the first time, make sure that you install the driver and the
software before connecting the camera to your computer. For installation details, see
“Setting Up the Camera” (page 7).
• When using software such as Network Smart Capture that can be used with this camera,
do not disconnect the cameras USB cable while running the software or when starting
up or quitting. Doing so can cause the computer to become unstable. Disconnect the
USB cable after all software have been shut down.
For Customers Using DVgate Motion
Before using DVgate Motion, make sure that you remove the cameras USB cable
from the USB connector of your computer.
Capturing images with the camera
You can use the Network Smart Capture software to capture images with
the camera. For details about how to install the Network Smart Capture
software, see “Installing the driver and the software” (page 7).
For operational details, refer to the Network Smart Capture software help.
1
Connect the camera to your computer.
The camera’s USB cable can be connected or disconnected while your
computer is on.
For details, see “Connecting the Camera” (page 14).
2
Start the Network Smart Capture software.