Sony PCGA-UVC11A - Manual (Page 24)

24 GB
3
Select “Sony PCGA-UVC11” in the Mixer device list, and
then click “OK”.
The “Capture” dialog box appears.
z
Hint
If the “Capture” dialog box does not appear, the driver may not be properly
installed. See “Checking that the driver is installed” (page 8), and check whether the
driver is properly installed.
4
Make sure that audio input from the camera microphone is
enabled.
Make sure that the “Mute all” check box is not selected. If it is, clear it.
5
Adjust the volume of camera microphone input.
Move the slider for the controller in step 4 to adjust the volume.
Make a video or audio recording using your software. If the audio plays
back correctly, the settings are complete.
If you cannot record with the camera microphone
Depending on your software, you may have to set the audio input device
manually. Follow the procedures below to set audio input device to the
camera microphone, according to your operating system.
z
Hint
If you are using the Network Smart Capture software, you do not need to perform the
procedures below.
With the Windows XP operating system
1
Click “Start”, and then click “Control Panel”.
“Control Panel” appears.
2
Click “Sounds, Speech and Audio Devices”.
The “Sounds, Speech, and Audio Devices” window appears.
3
Click “Sounds and Audio Devices”.
The “Sounds and Audio Devices Properties” dialog box appears.