Sony RCD-W3 - Manual (Page 23)

23
Additional Information
The sound has a lot of static.
Strong magnetism from a television or a similar
device is interfering with operations. Move the
recorder away from the source of strong
magnetism.
Other
No sound is output.
• Make the connections properly.
• Operate the amplifier properly.
• When using the headphones, turn PHONE
LEVEL to turn up the output level.
The remote does not operate the recorder.
• Make sure that there are no obstacles between the
recorder and the remote.
• Point the remote at the remote sensor on the
recorder.
• Replace the batteries in the remote.
After you’ve attempted the
prescribed remedies
If the recorder still does not operate properly, or
if other problems not described above occur,
turn off the recorder, then reinsert the plug into
the power outlet.
Should any problem persist even after
reinserting the power plug, consult your nearest
Sony dealer.
Troubleshooting
If you experience any of the following
difficulties while using the recorder, use this
troubleshooting guide to help you remedy the
problem before requesting repairs.
DECK A (the CD player
section)
The player does not start playing
• Insert a disc.
• Place the disc properly.
• Clean the disc.
• Place the disc with the label side up.
• Moisture condensation has formed inside the
recorder. Take the disc out and leave the recorder
turned on for about an hour until the moisture
evaporates.
• Press POWER to turn the recorder on.
DECK B (the CD-R and CD-RW
recording section)
The recorder does not operate or operates
poorly.
• The CD-R or CD-RW may be damaged. Replace
the disc.
The recorder does not start playing
• Moisture has formed inside the recorder. Take
the disc out and leave the recorder in a warm
place for several hours until the moisture
evaporates.
• Press POWER to turn the recorder on.
• Place the CD-R or CD-RW with the label side
up.
• Replace the CD-R or CD-RW with one that has
been recorded.
The recorder does not record
• The CD-R or CD-RW is finalized. Unfinalize
(for CD-RW only) the disc and try again.
• Make connections properly to the sound source.
• The sound source is not connected to the selected
input connector. Select the correct input
connector using INPUT.
• The recording level is not adjusted properly.
Adjust the recording level properly.
• There has been a power failure or the AC power
cord has been disconnected during recording.
Data recorded to that point may be lost.