Sony DHC-MD595 - Manual (Page 65)

Additional Information
65
Play does not start.
• Open the CD tray and check whether a CD is
loaded.
• Wipe the CD clean (see page 62).
• Replace the CD.
• Place the CD correctly in the center of the
tray.
• Place the CD in the tray with the label side
up.
• Remove the CD and wipe away the moisture
on the CD, then leave the system turned on
for a few hours until the moisture evaporates.
• Press CD HS to start play.
The sound skips.
• Wipe the CD clean (see page 62).
• Replace the CD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the
system, or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause
the sound to skip.
Play does not start from the first track.
• Press PLAY MODE repeatedly until
“PROGRAM” or “SHUFFLE” disappears to
return to normal play.
“—OVER—” appears.
• Keep pressing MD/CD .m to return to
the desired playing position.
MD Deck
An MD cannot be inserted.
• Insert the MD with the arrow side up and the
arrow pointing toward the deck.
The controls do not work.
• Replace the MD with a new one.
• Retry the operations after “TOC” turns off.
Play does not start.
• Replace the MD.
• Insert the MD and leave the system turned on
for a few hours until the moisture evaporates.
• Press MD HS to start play.
The sound skips.
• Replace the MD.
• Try moving the system to a place without
vibration (e.g., on top of a stable stand).
• Try moving the speakers away from the
system, or placing them on separate stands.
When you listen to a track with bass sounds at
high volume, the speaker vibration may cause
the sound to skip.
• Insert the disc and wait for 10 to 20 minutes
with the system turned on.
Play does not start from the first track.
• Press PLAY MODE repeatedly until
“PROGRAM” or “SHUFFLE” disappears to
return to normal play.
“—OVER—” appears.
• Keep pressing MD/CD .m to return to
the desired playing position.
“OVER” lights up during recording.
• Set the volume of the connected component
lower.
Recording or editing was done, but the
TOC is not updated.
• MD recording and editing contents are
recorded to the MD when the MD is removed,
so make sure you remove the MD after
recording or editing (see pages 24 and 37).
Recording is not possible.
• Remove the MD and slide the tab to close the
slot (see page 24).
• Connect the optional A/V component
properly (see pages 59 and 60).
• Switch to another sound source.
• Replace the MD with a recordable MD, or use
the Erase Function to erase unnecessary tracks
(see pages 40 – 43).
• Start recording over from the beginning.
continued