Sony STR-DA5500ES - Manual (Page 178)

178 GB
1
Press THEATER while pressing
RM SET UP.
The RM SET UP button lights up.
2
Press the input button
(including the TV button) for the
component you want to operate
with the new command.
The input button flashes. (The RM SET
UP button remains lit.)
3
Press the button on which you
want to store the new
command. For the buttons with
an asterisk in the illustration
above, press SHIFT, then press
the button.
The input button you selected in step 2
lights up. (The RM SET UP button
remains lit.)
4
Point the remote code receiver
section of the remote toward
the transmitter on the remote
commander to be learned from.
5
Press the button on the remote
commander to be learned from
to transmit the remote code.
While the remote of the receiver is
receiving the signal, the input button
selected in step 2 turns off.
The RM SET UP button flashes twice,
then the learning process is completed.
When the learning process fails, the RM
SET UP button flashes five times. Try to
perform process again from step 2.
6
Press RM SET UP to finish the
Learning function process.
Tips
• When the memory capacity for storing remote
commander codes reaches a certain limit, the RM
SET UP button flashes 10 times, and then the
learning process ends.
• If the RM SET UP button flashes five times in step
1, and the learning process does not start, replace
the batteries with new ones.
To cancel learning
Press RM SET UP. Also, not pressing any
button for 60 seconds cancels the settings.
When selecting a learned input,
press the button used to learn that
function.
To erase the learned code
1
Press THEATER while pressing RM
SET UP.
2 Press the input button for which you
want to clear the setting.
The input button flashes. (The RM SET UP
button remains lit.)
3 Press ?/1 for more than 1 second.
The input button flashes twice, repeatedly.
4
Press SHIFT, then press numeric
buttons to clear the stored setting.
The RM SET UP button flashes twice, then
the clearing process is completed.
When the clearing process fails, the RM
SET UP button flashes five times. Try to
perform process again from step 2.
About 5 cm - 10 cm (2" - 4")
Using a command that has been
learned