Video – Sony STR-DA5500ES User Manual
Page 188
188
GB
There is no picture or an unclear
picture appears on the TV screen or
monitor.
• Select the appropriate input on the receiver
• Set your TV to the appropriate input mode.
• Move your TV away from the audio
components.
• Assign the component video input
correctly.
• The input signal should be same as input
when you are up-converting an input
signal with this receiver (page 40).
The image of the COMPONENT VIDEO
OUT is corrupted.
• Video input signals other than 480p
component are not received when signals
are output from the VIDEO jack. Input
480i component video signals.
• When component input signals other than
480p are output, use the COMPONENT
VIDEO OUT jack and set “Resolution” to
“DIRECT.”
Images from the component connected
to the HDMI jack are not output to the
TV, are distorted, or are interrupted.
• The output of the HDMI video signals of
the receiver may be set to “OFF.” In this
case, select “HDMI A” or “HDMI B”
using the HDMI OUTPUT button
(page 116).
• If the compatible video format differs
between the monitors connected to the
HDMI OUT A jack and the HDMI OUT B
jack of the receiver, “HDMI A + B” may
not work.
• Depending on the playback component
you connect, “HDMI A + B” may not
work.
• Make sure that cables are correctly and
securely connected to components.
• Depending on the playback component,
component may need to be set up. Refer to
the operating instructions supplied with
the each component.
• Be sure to use a connecting cable for the
HDMI jack corresponding to high speed
(an HDMI version1.3a, category 2 cable)
when you view images or listen to sound
during a 1080p or Deep Color
transmission.
• Images from the component connected to
the HDMI jack may be distorted. In this
case, set “Video Direct” to “ON” in the
HDMI settings menu.
• Images or sound from the component
connected to the HDMI jack may be
interrupted when video signals are
switched. In this case, set “Video Direct”
to “ON” in the HDMI settings menu.
Recording cannot be carried out.
• Check that the components are connected
correctly (page 32).
• Select the source component (page 62).
The GUI does not appear on the TV
screen.
• “GUI MODE” may have been turned off.
Press GUI MODE to turn “GUI MODE”
on.
• Check the TV is connected correctly.
Images appear later than the
associated sound is played when the
HDMI input is selected.
• Depending on the component connected to
the HDMI jack, or the source played back,
images may appear later than the
associated sound. In this case, set “Video
Direct” to “ON” in the HDMI settings
menu.
Video