Panasonic DMWFL580LPP - Manual (Page 10)

VQT5F44
10
Flash Mode
Choose a flash mode according to your subject and shooting
conditions.
1 Press the [MODE] (3) button.
2 Rotate the dial to select a flash mode.
• While [MANUAL] or [FP MANUAL] is selected, pressing [MODE] (3) button
allows you to set the guide number. Press the [MODE] (3) again to turn back.
3 Press [OK] to set.
Control panel display Control operation
[ TTL AUTO]
The flash light intensity is controlled automatically
according to the camera’s setup. The flash will be
adjusted based on the brightness taken through the
camera’s lens. Usually use this mode with a camera
with communication capability.
[ AUTO]
Blinks:
Out of flash working range
The flash will be adjusted based on the brightness
captured by flash sensor on the flash. If the camera
has communication capability, this mode can be
used only when the camera is an AUTO-compatible
model.
[ MANUAL] In this mode, the flash is emitted according to the
guide number setting. The flash displays the
optimal range, which is calculated based on the
guide number and camera settings.
[ RC]
Wireless control is available with Panasonic digital
cameras that support wireless mode. (P13)
[ FP TTL AUTO] FP firing. This mode allows you to use flash
photography even at shutter speeds faster than the
flash synchronization speed of the camera.
≥ Maximum output is reduced, resulting in a smaller
flash working range. Flash working range also
diminishes with shutter speed.
[FP TTL AUTO]: Flash level is set automatically.
[FP MANUAL]: The flash fires at the selected guide
number. The flash displays the optimal range,
which is calculated based on the guide number and
camera settings.
[ FP MANUAL]
VQT5F44_ENG.fm 10 ページ ２０１４年２月１７日 月曜日 午後２時２２分