Panasonic DMWFL580LPP - Manual (Page 8)

VQT5F44
8
Continuous Firing
The flash may become hot when fired many times in succession, resulting in
damage or malfunction. The flash should be fired no more than 30 times in
succession at intervals of 2 seconds, after which it should be left unused for at least
10 minutes.
≥ When a filter is being used, we do not recommend firing with full flash intensity or
firing many times in succession. The heat caused by these firing methods may
deform the filter.
Preparing a Battery (optional)
Choose from the below batteries:
≥ LR6/AA Alkaline dry batteries (x 4)
≥ HR6/AA Rechargeable nickel metal hydride batteries (Ni-MH) (x 4)
The use of batteries made by Panasonic is recommended.
Loading Batteries
≥ Use alkaline dry batteries or rechargeable nickel
metal hydride batteries.
1 Slide the battery cover to open it.
2 Insert the batteries with correct [r]/
[s] polarity.
3 Close the battery cover by sliding it
back firmly as far as it will go.
Attaching to the Camera
Confirm that both the camera and flash are off. Attaching or removing the flash
while either the flash or the camera is on may result in malfunction.
1 Slide the lock lever in the direction
opposite to that indicated by the
[LOCK 1] icon (1).
2 Slide the flash into the hot shoe until
it clicks securely into place (2).
3 Slide the lock lever to the [LOCK 1]
position (3).
≥ To remove the flash, slide the lock lever in the direction opposite to the [LOCK1]
arrow and slide it from the shoe.
R6/AA Manganese dry batteries cannot be used.

 
VQT5F44_ENG.fm 8 ページ ２０１４年２月１７日 月曜日 午後２時２２分