Allied Telesis AR44xS series - Manual (Page 35)

Features in 276-02 35
Version 276-05
C613-10474-00 REV D
CR00011665 PRI 2 When using an unstructured TDM group over an E1 mode PRI interface,
occasionally a high level of errors was experienced. This may have caused the link
to be unstable, or may have resulted in reduced data throughput.
This issue has been resolved.
Y Y Y Y - - - - - -
CR00011746 BGP 2 If the router or switch failed to establish a BGP peer session because of
unsuccessful Open message exchanges, no further attempts to establish the peer
connection were made.
This issue has been resolved. The router or switch now continues to attempt to
establish the session, with 60 second intervals between attempts.
Y Y Y Y Y - - Y Y Y
CR00011780 BOOTP 2 Previously, if a user entered the command set bootp relay option82
port=portnum without also specifying one of the required subscriberid or
trusted parameters, the router or switch would incorrectly report “Operation
Successful”.
This issue has been resolved. The router or switch now reports that one of the
parameters subscriberid or trusted must also be specified as part of this
command.
Y Y Y Y Y Y Y Y Y Y
CR00011809 Firewall 2 The SIP application layer gateway (ALG) did not correctly handle SIP packets that
had an extension parameter added to the “From” field. In VoIP networks that
added this extension parameter, users telephoning out from the private network
could not hear the recipient talk, because the VoIP voice data was not passed
from the remote client to the client on the private side.
This issue has been resolved.
Y Y Y Y Y - - - - Y
CR00011844 IPv6 2 IPv6 interfaces did not work over a PPP link on switches or AR44x routers. When
the interface received IPv6 traffic, the router or switch rebooted.
This issue has been resolved.
Y - - Y Y - - Y Y Y
CR Module Level Description AR44x
S /
AR4
50S
AR7x5 AR750
S
Rapi
er
i
A
T-
880
0
A
T-
860
0
A
T-
870
0XL
A
T-
894
8
A
T-
990
0
A
T-
980
0