Allied Telesis AR44xS series - Manual (Page 36)

Features in 276-02 36
Version 276-05
C613-10474-00 REV D
CR00011855 TCP,
UPnP
2 TCP sessions would sometimes “hang” in the Close Wait state. This behaviour
occurred when a UPnP notification session was closed by the control point
(usually Windows XP, SP2), via a “200 OK” message that contained a
“Connection: close” field, that also had the TCP/FIN flag set.
Because these TCP sessions were not closing, eventually all available TCP
resources could be used up, preventing new TCP sessions from opening.
This issue has been resolved. Such TCP sessions now close correctly.
Y Y Y - - - - - - -
CR00011940 Switch 2 Previously, if all configured IP interfaces were down or had been deleted,
broadcast frames were not sent to the switch’s CPU. This meant, for example,
that VLANs on the switch did not receive PPPoE traffic if all IP interfaces were
down. - - - - - - - Y Y -
CR00011991 WAN load
balancer
2 An issue occurred when the router accessed multiple WAN load balancer
healthcheck hosts, and was configured as a firewall that performed enhanced
NAT. Instead of testing the health of each healthcheck host through every WAN
LB resource (and therefore over all relevant WAN interfaces), the router only
tested through one WAN LB resource. If that one WAN interface lost connectivity
to the Internet, the WAN LB incorrectly thought that all WAN LB resources had
become unavailable.
This issue has been resolved. The WAN LB now correctly checks the health of all
healthcheck hosts through all WAN LB resource interfaces.
Y Y Y - - - - - - -
CR00011992 Firewall 2 When the firewall was enabled, it failed to process some RTSP packets, so clients
behind the firewall failed to load some web pages that used RTSP (TCP port
7070).
This issue has been resolved.
Y Y Y Y Y - - - - Y
CR Module Level Description AR44x
S /
AR4
50S
AR7x5 AR750
S
Rapi
er
i
A
T-
880
0
A
T-
860
0
A
T-
870
0XL
A
T-
894
8
A
T-
990
0
A
T-
980
0