CatEye e-TrainData™ Ver.3 [Power Unit Edition] - Manual (Page 15)

15
e-Train Data V3
START/STOP/ENTER button
START/STOP/ENTER
LAP
START/STOP/ENTER
LAP
MODE-2 button
START/STOP/ENTER
LAP
MENU button
DOWNLOADING DATA
1. Check that the CC-TR100 is attached and that the power unit has been connected to the PC securely.
Then launch Windows. (See page 12.)
2. Press the [MENU] button of CC-TR100.
3. Press the [MODE-2] button of CC-TR100 until the “PC Link” screen appears on CC-TR100.
4. Press the [START/STOP/ENTER] button of CC-TR100.
When the CCTR-100 is connected to the PC for the first time or after formatting, the user’s registration
screen appears. Enter the user name and click the “OK” button.
5. When the PC acknowledges the connection with CC-TR100, the message “COMPUTER ACKNOWL-
EDGED” appears.
The “Online Torque Measurement” screen appears on the CC-TR100 display. Press the [MODE-1] or
[MODE-2] button of the CC-TR100 to bring up the “PC Online” screen.
IMPORTANT!
When “Power Select” on the CC-TR100 setting is OFF, “Line Error” appears and the CC-TR100 is not
connected to the PC.
NOTE
With the “Online Torque Measurement” screen displayed, press the [START/STOP/ENTER] button to
start online torque measurement.
MODE- 1
or
MODE- 2
If the connection to CC-TR100 cannot be established, check the following
• Check the connection between the Power Unit and the PC.
• Check the connection between the Power Unit and CC-TR100.
• Restart the PC, and follow the connecting procedure again.
• Refer to additional troubleshooting on page 52.
If the connection is still not established, reinstall e-Train Data Ver. 3.
The “PC Online” screen The “Online Power Measurement” screen
PC Link Icon