Set up a pppoa or pppoe routed session – ADC MM701G2 User Manual
Page 101
Appendix A: Command Line Interface Access
A-13
Set Up a PPPoA or PPPoE Routed Session
You selected Create PPPoA routed session or Create PPPoE routed session from the WAN Session
Management menu (
) to display the following menu. The PPPoA routed session
configuration is shown below as an example. The configuration parameters for PPPoE routed session are identical.
Figure A-10. PPPoA Routed Session
Step
Action
1
Configure the following parameters, 1 through 15, for the PPP session:
• Session Name
Enter 1 then type a unique, descriptive identifier for the session. This name can have a maximum of
32 characters.
• Virtual Path ID (VPI)
Enter 2 then type the value (from 0 to 4,095) provided by the service provider. The number identifies
the virtual path that transports ATM cells between the modem and the service provider. This value
must match the virtual path identification (VPI) value the service provider uses for this connection.
• Virtual Channel ID (VCI)
Enter 3 then type the value (from 32 to 65,535) provided by the service provider. The number
identifies the virtual channel for this session that transports ATM cells between the modem and the
service provider. This value must match the virtual channel identification (VCI) value the service
provider uses for this connection.
• QoS Class
Enter 4 then select the ATM Quality of Service indicated by your service provider. The options are:
1—CBR (constant bit rate)
2—VBR-rt (variable bit rate real-time)
3—VBR-nrt (variable bit rate non-real-time)
4—UBR (unspecified bit rate is the default setting)