Set up the lan, Figure a-6. lan configuration, Go to – ADC MM701G2 User Manual
Page 94
Advertising
Appendix A: Command Line Interface Access
A-6
Set Up the LAN
If you are operating in Router mode and in a LAN environment, then you also need to set your LAN protocol,
Ethernet Port IP address, and subnet mask.
If you prefer, you may use the default values of 10.0.0.1 for the Ethernet Port IP Address, and 255.255.255.0 for the
subnet mask.
Step
Action
1
From the System Management main menu (
), enter 2 to display the LAN
Configuration menu (
Figure A-6. LAN Configuration
NOTE: The LAN Protocol can only be changed through the Command Line Interface.
Advertising
This manual is related to the following products: