Vaddio ProductionVIEW Super Joystick - Manual (Page 10)

ProductionVIEW Super Joystick
ProductionVIEW Super Joystick Manual 341-565 Rev. B Page 10 of 16
Zoom Direction
>Select
>Normal or Invert (default is Normal)
Inverts the Joystick Zoom Direction (Inverted - Clockwise twist = zoom out)
Panel Lights
>Select
>00
through 50
Panel Light Brightness (all lights - 50 is the brightest) (default is 25, off is 00)
Switching Modes
(For Camera Selection - Manual or tying Camera Selection to Ext. Control A or Ext. Control B):
>Select
>Manual
Camera Selection Button operate independently from Ext. Control A or Ext. Control B Buttons
> Follow Ext A
Camera Selection Buttons follow Ext. A Control Button Pushes
When assigned, Camera Selection switching follows the External A button selection, immediately
transferring joystick and camera control directly to the camera selected on the Ext. A bus.
> Follow Ext B
Camera Selection Buttons follow Ext. B Control Button Pushes
When assigned, Camera Selection switching follows the External B button selection, immediately
transferring joystick and camera control directly to the camera selected on the Ext. B bus.
Video Switcher
>Select
>None
External Control A and External Control B buttons report out via RS-232
>Edirol 3S, 3H
3 Std. Def. and 3 High Def. Input Configuration
>Edirol 4S, 2H
4 Std. Def. and 2 High Def. Input Configuration
>Edirol 4H, 2S
4 High Def. and 2 Std. Def. Input Configuration
*For use with Edirol V-44SW Multi-Format Switcher (6 channels only)
>Analog Way (supports Analog Way Eventix EVX8022 Switcher) Channels 1 through 6 only.
>Extron (Supports Extron ISS-506 6x2 Integration Switcher)
Note:
Other switchers may be added in future firmware releases.
Transition Time
>Select
>0.0 - 4.0 Transition Timer, 0.0 to 4.0 seconds for use with Edirol, Extron and Analog Way Switchers
Ext. Triggers
>Select
>Active High
>Active Low
Select Active High or Active Low depending on the requirements of the attached device. External Control
Triggers/Tally contacts are latching, TTL type. These triggers are not relays and no voltage should be applied
to these triggers at any time. The External Control switches on the front panel correspond directly to the
External Control Triggers/Tally on the rear panel.
System Menu
>Select
>Serial Input
>Select
>Yes
or No
Turns on or off serial input (default is Yes or On)
>Serial Echo
>Select
>Yes
or No
Turns Serial Echo on or off (default is Yes or On)