Vaddio ProductionVIEW Super Joystick - Manual (Page 5)

ProductionVIEW Super Joystick
ProductionVIEW Super Joystick Manual 341-565 Rev. B Page 5 of 16
Pin 6: GND
Pin 7: TXD
Pin 8: RXD
ProductionVIEW Super Joystick Back Panel I/O and Controls (Figure 3):
1) POWER INPUT
• Use only the 18 VDC, 2.75A power supply provided with the ProductionVIEW Super Joystick.
Use of any other power supply may cause damage to the ProductionVIEW and to the
products attached.
• Connector 5.5mm OD, 2.5mm ID, positive center
2) 3-AXIS HALL-EFFECT JOYSTICK
• Pan/Tilt/Zoom Control, Side view - shown with rubber boot.
3) CAMERA CONTROL PORTS on RJ-45 connectors
• One camera control port per camera (no daisy-chaining required)
4) RS-232 CONTROL PORT
• DB-9 for RS-232 control of internal functions (Pin 2 = TX, Pin 3 = RX, Pin 5 = GND) for use
with external controllers or external production switchers
5) EXTERNAL CONTROL TRIGGERS/TALLYS
• For use with tally lights or external devices (i.e. video switchers or control systems). These
external control contacts correspond directly to front panel EXTERNAL CONTROL A (1
through 6) and EXTERNAL CONTROL B (1 through 6) switches on the front panel.
• External Control Triggers/Tally contacts are latching, TTL type. These triggers are not relays
and no voltage should be applied to these triggers at any time. The triggers are configurable
as Active High or Active Low.
6) EXTERNAL VIDEO INPUTS (A & B)
• Composite video inputs on BNC connectors, 1 V p-p, and 75Ω for display on built-in 4”
preview monitor.
7) RJ-45 Pin–outs
• Pin-out reference for RS-232 control over Cat-5 (Cat. 5e) cabling
• Pin 6: GND
• Pin 7: TXD
• Pin 8: RXD
1 2 3 5
6 7
4
Pin 2: TX
Pin 3: RX
Pin 5: GND