Vaddio ProductionVIEW Super Joystick - Manual (Page 13)

ProductionVIEW Super Joystick
ProductionVIEW Super Joystick Manual 341-565 Rev. B Page 13 of 16
Command Structure Definitions
Command Description
AWB x (On/Off) Turns auto white balance on or off on controlled camera.
BLC x (On/Off) Turns backlight compensation on or off on controlled camera.
Bright x
(UP) Turns brightness up one increment, (Down) Turns brightness down one increment, (Auto) restores
auto brightness on controlled camera.
Camera x (1-6) Switch control function to camera x.
CHAIn x External Control A (1-6)
CHBIn x External Control B (1-6)
ClearAll Clears ALL presets.
Config Displays the current configuration.
DefaultCam x (1-6) This camera will be activated at startup
Display x (CHB/CHA/Off) Selects what will be viewed on the internal LCD screen.
DspCams x Lists connected cameras
ExtTrigger x Select active high or active low (Low/High)
Focus x (Auto) restores auto-focus, (Near) focus near, (Far) focus far, (Stop) stops near and far focus
InvertPan x (Yes) Changes pan direction on all cameras. (No) Normal direction.
InvertTilt x (Yes) Changes tilt direction on all cameras. (No) Normal direction.
InvertZoom x (Yes) Changes zoom direction (No) Normal direction.
Move x (Up/Down/Stop/Left/Right) Moves or stops controlled camera.
OnCamInit x (Home/Preset 12) Homes default camera or sends all camera to Preset 12 upon power up
PanSpeed x (1-24) Changes pan speed on all cameras 24=fastest. This is the pan speed between presets only.
PanMaxSpd x (1-24) Sets Pan Speed Range - 24 Fastest
Pass(cr) Passes next string to controlled camera (camera response, if any, is not passed back)
Power x (On) Starts ProductionVIEW, (Off) Places ProductionVIEW and all controlled cameras into standby mode
Preset x (1-12) Go to preset x on controlled camera.
PresetLoc x (InCam/Lcl) Preset location - Local is all 12 internal - InCam is 6 in the cameras and 6 internal
Rescan Rescans for attached cameras.
Reset Reboots system
SerialEcho x (Yes) Serial commands sent to the ProductionVIEW SJ will be echoed back. (No) Not echoed.
SerialInfo x
(On) Shows console button pushes to RS232 host port. These commands the same as the input serial
commands (Off) Does not show these button pushes.
SetDefault x (1-12) Set Default Preset
Store x (1-12) Stores preset x for the controlled camera.
SwitchMode x CamSel - (CHA/CHB/Manual) Sets Camera Selection to follow Ext A or External B button pushes
TiltSpeed x (1-20) Changes tilt speed on all cameras 20 = fastest. This is the tilt speed between presets only.
TiltMaxSpd x (1-24) Sets Tilt Speed Range - 24 Fastest
Version Displays Firmware version installed
Zoom x (In) Zooms in (Out) Zooms out (Stop) Stops Zoom - On controlled camera.