Vaddio ProductionVIEW Super Joystick - Manual (Page 7)

ProductionVIEW Super Joystick
ProductionVIEW Super Joystick Manual 341-565 Rev. B Page 7 of 16
Operating the ProductionVIEW Super Joystick:
Master Power Switch
• When the Master Power Switch is powered down, all of the attached cameras will be placed in
standby.
• When the Master Power Switch is powered up, all attached cameras will activate and select
default camera and preset information as defined in the menu. The ProductionVIEW Super
Joystick will scan the inputs for camera type and video signal type and auto-configure
accordingly. This can take up to one minute and is normal operation.
• To power down the ProductionVIEW, press and hold the button for 1 second. This feature
eliminates the accidental powering down of the system if the Power switch is bumped.
Important Note: When the camera control ports are changed or reconfigured, the ProductionVIEW
Super Joystick must be restarted (power cycled) or the cameras must be rescanned for type of camera to
allow reloading of the proper control codes.
Figure 5: System Configuration - High Definition Video
• Cameras are controlled by the Super Joystick
• Video is handled by an external video switcher
• External Switcher is controlled by the Super Joystick via RS-232
•
System is shown with Edirol V-44SW In Edirol V-44SW Mode (4HD - 2SD)
RS-232
RS-232
HD Video
HD Video
HD Video Monitor
ProductionVIEW Super Joystick
In Edirol V-44SW Mode (4HD - 2SD)
Edirol V-44SW
Power and
HD Video
WallVIEW HD1 Camera Systems
Quick-Connect Pro HD1
RS-232 Codes for Edirol
V-44SW are Built-in