Vaddio WallVIEW HD-18W User Manual
Page 4
WallVIEW HD-18
WallVIEW HD-18 Manual 341-888 Rev. D
Page 4 of 16
5.
RS-232 In & IR Out – The RS-232 accepts modified VISCA™ protocol for camera control, as well
as transmits IR signaling received by the IR receivers, which can be transmitted to third party
devices.
6.
DIP Switch Settings – Settings for IR remote, baud rate, SD output format, image flip can be
configured on these switches. See page 6 for additional information switch settings.
7.
HD Video Select – A rotary switch allows the user to choose the component HD output video
resolution and format. See page 6 for additional information on switch settings.
8.
12 VDC Input – NOTE: The power input is not used with the WallVIEW HD-18 system. This is only
used on the standard, ClearVIEW HD-18 camera.
9.
YPbPr Video Output – Component HD video is fed through the DB-15 connector.
10.
SD Video Output – Standard definition video is fed through the BNC connector.
11.
EZ Port – CAT-5 cable (up to 100 feet) is connected to the Quick-Connect SR. The EZ-Port
supplies power to the camera and delivers component HD video up to 100 feet.
12.
Slot for Optional Cards – Optional slot cards can be plugged into the WallVIEW HD-18 camera
through the slot in the back of the camera base.
Rear of WallVIEW HD-18
5
6
7
8
9
10
11
12