Vaddio WallVIEW HD-18W User Manual
Page 6
WallVIEW HD-18
WallVIEW HD-18 Manual 341-888 Rev. D
Page 6 of 16
Getting Started:
First, set up the HD and SD output resolutions for the camera, along with IR output, baud rate and image
flip. On the next page are the options for the switches that are found on the back of the camera.
Figure 5: Dip Switch and HD Video Output Resolution Setting Options for the HD-18 Camera
Note: The Test Bars are non standard, but are 75% YCbCr Color Bars and are intended as a
convenience for testing the signal path only.
IR 1, 2 & 3: These settings, using switches 1 & 2, determine the IR frequency of the IR remote control
that was supplied with your camera. The IR remote has the capability of operating up to three different
PTZ cameras from one remote, using the selector buttons at the top of the remote.
IR Out: The IR output is sent on the RJ-45, RS-232 jack on the back of the camera. Turning on the IR
output will allow IR signals to be transmitted over the CAT-5 cable.
Baud Rate: The options for baud rate are either 9600 or 38,400 for RS-232.
SD Output Frequency: Select either NTSC or PAL as the output for the camera’s SD signal that is
transmitted on the BNC connector.
SD Output Size: Three options are available for the SD output, select from crop, squeeze or letterbox.
Image Flip: Turing Image Flip on (switch down), will allow the camera to be inverted.
Test Bars: Turning this switch on will override the camera video output and send test video bars from
the camera to the CCU to allow more accurate setting of the video level at the CCU.
Switch 10: This switch is unused, and should be left in the OFF position.
Before Installing
Locate the camera mounting location paying close attention to camera viewing angles, lighting
conditions, possible line of site obstructions, and checking for in-wall obstructions where the camera
is to be mounted. Pick a mounting location to optimize the performance of the camera.
Pre-wire all cabling as required (see wiring diagram examples).
The CONCEAL Wall Mounting System for the WallVIEW HD-18 can be mounted directly to a 2-gang
wall box or can be mounted to the drywall using the supplied four (4) drywall anchors.
IR 1
1 & 2 UP
ON
SD
NTSC
SD
PAL
SD 4:3
6 & 7 UP
SD
LB
IMAGE
FLIP
OFF
ON
ON
DIP SWITCH SETTINGS
8
1
2
3
4
5
6
7
9
10
HD VIDEO SELECT
720p/59.94
1080i/59.94
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
1080p/59.94
1080p/60
720p/50
1080i/50
1080p/50
2
1
5
4
3
7
6
8
10
9
ON
IR 2
ON
IR 3
ON
IR
OUT
OFF
9600
bps
38400
bps
SD
SQ
TEST
BARS
OFF
10
OFF
480i/29.97
1080p/25
1080p/30
576i/25