Vaddio WallVIEW HD-18W - Manual (Page 8)

WallVIEW HD-18
WallVIEW HD-18 Manual 341-888 Rev. D Page 8 of 16
The two (2) Cat-5e cables should feed-through a 1”(25.4mm) opening (circular or square shape) centered
in the rectangular slot located on the rear flange of the CONCEAL Wall Mount Bracket (see Fig. 7).
Note: Do not cut out the entire rectangular slot opening in the wall! This will not allow the two (2)
lower wall anchors to correctly fasten the Conceal Wall Mount to the wall (see Fig. 7).
If the bracket is to be mounted on a 2-gang wall box, use the screws supplied with the wall box cover
plate to attach the CONCEAL Wall Mount Bracket.
If mounting to drywall with wall anchors, use the four (4) quality wall anchors/screws provided (see Fig. 7).
Note: The mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount
and tighten the mounting screws.
Note: Check all Cat-5e cables for continuity in advance of final connection.
Plugging the EZ POWER/VIDEO Cat-5e Cable into the wrong RJ-45 may cause
damage to the camera system and void the warranty!
Step 2: SECURE THE CAMERA TO THE CONCEAL WALL MOUNT BRACKET:
After all cables are attached to the camera, place the camera onto the camera mount and insert the two-
(1/4”-20) screws into the camera through the two-screw holes in the bottom of the mount.
Note: Be sure to align each side of the camera evenly to all sides of the CONCEAL Wall Mount
Bracket before final tightening of the mounting screws (see Fig. 8).
Step 3: INSTALL THE CONCEAL LOWER COVER PLATE:
Attach lower CONCEAL Lower Cover Plate (see Fig. 9). Slide lower cover plate from front of the
mounting bracket toward the rear of the bracket. The two-rear locking tabs will need to be guided into
position first and will lock in place as the lower cover plate is pushed toward the rear of the mounting
bracket and the front tabs are inserted (see Fig. 10).
Step 4: INSTALL THE CONCEAL REAR CAMERA COVER:
After successful testing of the camera, install the Conceal Rear Camera Cover on the CONCEAL
Mounting Bracket with the supplied screw (see Fig. 11 and 12).
Fig. 7: CONCEAL Wall Mount
Bracket:
Cabled and Attached to Wall
Fig. 8: Vaddio HD-18 Camera aligned
and attached to the CONCEAL Wall
Mount Bracket (by two-(1/4”-20)
screws in the bottom of the mount)
Fig. 9: CONCEAL Lower Cover Plate
with Locking Tabs
Fig. 10: CONCEAL Lower Cover Plate
locked in place
Fig. 11: CONCEAL Rear Camera Cover
Fig. 12: Completed CONCEAL Wall
Mount Camera Bracket Installation