Vaddio WallVIEW HD-18W User Manual
Page 7
WallVIEW HD-18
WallVIEW HD-18 Manual 341-888 Rev. D
Page 7 of 16
Figure 6: Standard wiring configuration of the camera to a Vaddio Joystick controller.
Mounting and Installation Instructions for the CONCEAL Wall Mounting System:
Step 1: Determine Camera Mount Location:
When locating the camera, consider viewing angles, lighting conditions, possible line of site obstructions
and check for in-wall obstructions where the camera is to be mounted. Pick a mounting location to
optimize the performance of the camera. After determining the optimum location of the camera system,
route the required two (2) Cat-5e cables from the camera to the head-end.
Rear
Panel
HD-18
RS-232
Cat 5e
Rear Panel
HD-18 QC SR
(Equipment
Head-end)
YPbPr & Power on one (1) Cat 5e up to 100’ (30.48m)
YPbPr
24V - 2A
Power Supply
HD Monitor
(Simulated Feed)
ProductionVIEW Precision Camera Controller
←
YPbPr
Power
→