Vaddio WallVIEW HD-18W - Manual (Page 5)

WallVIEW HD-18
WallVIEW HD-18 Manual 341-888 Rev. D Page 5 of 16
Figure 4: Quick-Connect SR (rear)
13.
Power Input – The 24 VDC power adapter powers the Quick-Connect SR and also sends power to
the HD-18 camera.
14. Power & HD Video – The CAT-5 connection that extends to the EZ-Port Power/Video connector on
the HD-18 camera. Maximum distance on the CAT-5 cable is 100 feet (30.5 m).
15. HD Video Output – DB-15 connector that outputs the component HD video extended from the
camera over CAT-5 cabling.
16. IR Output – With the IR pass-thru turned on at the camera (see Camera Settings section), send IR
from third-party IR remote controls to third-party equipment, such as videoconference codecs. IR
can be transmitted as either modulated or non-modulated signals for added flexibility.
17. RS-232 Input & Output Jacks – When using the IR pass-thru function, the IR signals are pulled
from the CAT-5 RS-232 cable and delivered as modulated and non-modulated signals to the IR
Output ports.
First Time Set-up with the WallVIEW HD-18:
WallVIEW HD-18 was designed to be exceptionally easy to use and operate. There is documentation at
the back of the manual for pin-outs for all of the connectors on the WallVIEW HD-18 camera.
RS-232 Cabling
For RS-232, use a standard Cat-5e cable (568B termination for RJ-45 connectors) from the RS-232 port
on the back of a Vaddio ProductionVIEW camera controller or switcher. If the camera will be connected
to a third-party control system (such as AMX or Crestron), a DB-9 to RJ-45 adapter cable is supplied with
the camera for RS-232. Use of pass-thru RJ-45 connectors should not be used (see notice on page 2).
Videoconference Codecs and RS-232
Depending on the codec that is used, and which RS-232 port is used with a codec, special DB-9 to RJ-45
adapters may sometimes be required. Refer to Vaddio’s website for Tech Notes on the WallVIEW HD-18
page on specific diagrams for wiring the camera to videoconference codecs. Any special adapters and
configuration information will be noted on the Tech Note.
INSTALLATION
The WallVIEW HD-18 product was specifically designed for installation on a vertical wall surface with Cat-
5e cable connectivity for Power, Video and Control signaling (two cables are required). Installation is
simplified in that no custom 8-Pin mini-din cables or expensive S-Video plenum cables are needed and
no power outlets are required near the camera bracket. All cabling is routed to the head-end using Cat-
5e cables.
13
14
15
16
17