Fagor 3CF-540SI BUT - Manual (Page 39)

39
gap H in mm (fi g. 6 for the grill).
Burner G20
20mbar
G30 28-30mbar
31 37mbar
Oven
Grillr -
4
-
8
Check operation of the burner:
- Ignite the burner at maximum fl ame;
- the tongue of the fl ame must be clear and
with no yellow tip, and must adhere closely
to the burner. If too much air is supplied, the
fl ame detaches from the burner and may be
dangerous. If the air supply is insuffi cient,
the fl ame has a yellow tip and soot may
form.
SETTING HOB BURNER MINIMUM LEV-
ELS
If the cooker is to work on bottled gas (butane/
propane), the tap by-pass must be screwed
right down.The cooker may be equipped with
type A taps, with by-pass inside (accessed by
inserting a small screwdriver into the rod) or
type B taps, with by-pass on the outside on the
right (accessed directly). See fi gure 7.
If the cooker is to work on natural gas, proceed
as follows for both types of tap:
- Ignite the burner at maximum fl ame;
- pull off the knob, without using a lever
against the control panel, which might be
damaged;
- access the by-pass with a small screwdriver
and back off by about 3 turns (turning the
screwdriver anti-clockwise);
- turn the tap rod anti-clockwise again until
it stops: the burner will be at maximum
fl ame;
- screw the by-pass slowly back in, without
pushing the screw-driver, until the fl ame has
apparently shrunk to 1/4 of the maximum
size, checking that it is suffi ciently stable
even in quite strong draughts.
SETTING OVEN BURNER MINIMUM LEV-
ELS
If the cooker is to work on bottled gas (bu-
tane/propane), the thermostat by-pass must
be screwed right down.If the cooker is to work
on natural gas, proceed as follows:
- Remove the oven bottom (push towards the
back and raise);
- ignite the oven burner, turning the knob
pointer to the maximum setting;
- shut the oven door;
- access the thermostat or tap by-pass (see
fi g. 8);
- back off the thermostat by-pass by about 3
turns;
- after 5 or 6 minutes, turn the knob pointer to
the minimum setting;
- slowly re-tighten the by-pass, watching the
fl ame decrease in size through the window in
the closed oven door until the tongue of the
fl ame is about 4 mm long. Never keep the
fl ame too low. It must be stable even when
the oven door is opened or closed quickly;
- turn off the burner and replace the oven
bottom.
CONNECTING TO THE ELECTRICAL
MAINS
Before making the connection, check that:
- the mains voltage is as indicated on the
nameplate;
- the earth connection is in good working
order.
Except in the case where the appliance is
fi tted with a power supply cable featuring a
plug, and the same remains accessible after
installation is completed, the fi tter should
insert an omnipolar switch with a minimum
contact opening of 3 mm. If the appliance
is fi tted with a power supply cable without a
plug, the connection can be made by adding
a standard-compliant plug or a connection
bridge directly. When making this connection,
keep the following in mind:
- the yellow-green wire should be connected
to the earth connection
- the blue wire to neutral
Installation GB