NOVUS superview - Manual (Page 4)

NOVUS AUTOMATION 4/38
INSTALLATION
SYSTEM REQUIREMENTS
The following are necessary for using SuperView:
• A PC-Compatible computer running Windows XP or higher operational system. The minimum specification for this
computer is:
Processor AMD or INTEL 2 GHz
Free space on dick: 300 MB
RAM: 1 GB (2 GB Recommended)
Mouse, Keyboard, SVGA Monitor, Serial or USB Ports
NETWORK Interface
• In order to execute SuperView set up in Server or Local mode, one or more devices with communication through
the MODBUS RTU Slave or MODBUS TCP protocol are necessary. If this device uses a RS485 communication
interface, a converter RS232/RS485 will also be necessary (if communication through the PC serial port is used)
or a USB/RS485 converter (if communication through the PC USB port is used – Requires Windows 2000, XP or
higher).
INSTALLATION PROCEDURES
To provide the SuperView installation, the computer user shall have the privilege of an administrator and an
unrestricted access to the Windows folders.
For the SuperView installation on your computer follow the steps below:
1. Insert the installation CD in the CD driver
2. The SuperView installation program shall start automatically in a few moments. If it does not launch automatically,
run it manually from D:\Setup.exe (considering that D: is the letter that identifies your CD driver).
3. Follow the instructions prompted on the screen till the installation is complete.