Goulds Pumps 3298 - IOM - Manual (Page 79)

Maintenance
b) Install the two guide rods (B03189A) into the clamp ring (141C).
These rods help you guide the casing assembly into the C-face support and frame
(228), which contains the drive magnets (740B).
1. Casing assembly
2. Guide rods
Figure 71: Casing assembly with guide rods
4. Slide the casing assembly into the C-face support and bearing frame assembly:
If your pump group is... Then...
XS or S
1. Hold the casing firmly by the suction flange and suction side of the
discharge flange.
Keep hands away from the clamp ring in order to avoid pinched
fingers.
2. Slowly insert the casing in order to avoid damage.
M or L
1. Position the casing assembly so that the two guide rods are
engaged into two of the C-face support and frame capscrew holes
and the jacking screws (418) contact the casing assembly clamp
ring (141C).
2. Loosen the jacking screws (418) and slowly draw the casing
assembly into the C-face support and bearing frame assembly.
Keep hands away from clamp ring to avoid pinched fingers.
1. Casing assembly
2. Guide rods
5. Secure with four hex capscrews (370B) and tighten.
Assembly references
Bolt torque values
Location Dry threads torque in ft-lbs (Nm)
Hex nut – 355A 30 (40)
Clamp ring screws – 356A 30 (40)
Support / frame screws – 370B 30 (40)
3298 Family Installation, Operation, and Maintenance Manual 77