Glastender GW24 - Manual (Page 8)

6 Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
c
ontrol
p
anel
- W
ash
c
ycle
W
ash
c
ycle
d
escrIptIon
:
1. Load the conveyor with glassware. To aid in loading the conveyor,
rotate the conveyor 1/2 turn by pressing the Conveyor Advance
button on the control panel.
2. Close the sliding cover.
3. Cycle is initiated by pressing the Cycle Start button on the control
panel. Once in cycle, the red In Use light will illuminate.
4. Wash water fill is initiated and the drain will close when hot water
is sensed or 15 seconds into the cycle, whichever is sooner.
5. Detergent is automatically injected into the tank during fill. The
sliding cover can be opened during fill to visually verify detergent
is being injected into wash water.*
6. The wash cycle will automatically start once full. Opening the
sliding cover during the wash cycle will pause the cycle, turning off
the recirculating pump and conveyor. Closing the sliding cover will
continue the cycle.*
7. At the completion of the wash cycle, the wash water will drain.
8. The rinse water fill is initiated with the drain open to rinse detergent
from the tank. The drain then closes to allow the tank to fill.
9. Sanitizer and Rinse Aid are automatically injected into the tank
during fill. The sliding cover can be opened during fill to visually
verify chemicals are being injected into the rinse water.*
10. The rinse cycle automatically starts once the tank if full. Opening
the sliding cover during the rise cycle will pause the cycle, turning
off the recirculating pump and conveyor. Closing the sliding cover
will continue the cycle.*
11. At the completion of the rinse cycle, the rinse water will drain.
12. The red In Use light will turn off, indicating that the cycle is
complete.
13. Open the sliding cover.
14. Unload the glassware from the conveyor. Pressing the Conveyor
Advance button will rotate the conveyor 1/2 turn to aid in unloading
the conveyor.
* NOTE: If the sliding cover is open for more than 30 seconds, the
cycle will terminate and the tank will drain. Press Cycle Start to
initiate a new cycle.
Cycle
Start
Conveyor
Advance
Detergent
Prime
Sanitizer/
Rinse Aid
Prime
De-liming
Power In Use
Control Panel Operation
Cycle Start - Push to start wash cycle
Power - Green light* indicates power to
unit when illuminated
In Use - Red light* indicates cycle in
progress when illuminated
Conveyor Advance - Push to rotate
conveyor 1/2 turn to aid in loading/
unloading glassware
Detergent Prime - Push and hold to
prime detergent
Sanitizer / Rinse Aid Prime - Push and
hold to prime sanitizer and rinse aid
De-liming - Push to start de-liming cycle
* Alternating flashing of the red and green
light indicates the sliding cover interlock
switch has interrupted cycle or a chemical
detection switch (optional accessory) has
detected a chemical outage.