Rugged Ridge PowerTop Kit, 07-14 Jeep Wrangler Unlimited (JK), Black - Manual (Page 13)

Section B Page 11
Once adjustments have been made, tighten the side
assemblies to the tub rail.
The next step will be to create an equal space between
the side arm assemblies and the top of the roll bar on
both sides of the vehicle and to ensure adequate
clearance of the roll bar.
Adjust the tilt of the side arm assembly to clear the vehicles
roll bar by adding spacers. Note: 8 spacers (5/16
washers) have been provided in the hardware kit for
adjustment. After the tilt of the side arm assemblies have
been aligned, tighten the bottom mounts .
Align the side arm assembly with the edge of the belt
rail.
10 7
8 5
©2012
Attach the bottom half of the factory header to the
vehicle. Secure the headers latches to the vehicle.
6
Manually push/pull the side arm assembly up to extend. Aim
the assembly by rotating the rear most mounting point. The
front tube should fall into or above the u-shaped cutout in the
header.
Entanglement & Pinch Hazard. Keep
Power Top fee from obstructions.
9
5/16 Washers
(Spacers)
WARNING !
CONTINUED...