Rugged Ridge PowerTop Kit, 07-14 Jeep Wrangler Unlimited (JK), Black - Manual (Page 29)

Section F Page 27
Apply a 5 inch section of foam tape to the front
surrounds. Tape should overlap onto vehicle at the front.
Confirm that pre-adjusted set screws are correctly adjusted.
With the Power Top in the open position, tighten set screw 2 until
it pushes against the wall of the side arm assemblies. Close the
Power Top, do not latch it. Tighten set screw 1 until it pushes
against the wall of the side arm assemblies.
9
4
©2012
2
1
With the Power Top in the open position, unzip roll bar
covers and attach rear surrounds to vehicle roll bar
starting with the back as shown.
Unzip roll bar covers and secure the other side of the
rear surrounds to the B-pillar.
5
6
3/8x3.75
Hex Bolt
3/8 Washer
3/8 Nut
#10x1 Button
Head Bolt
#10 Washer
#10 Flange
Nut
Unzip roll bar covers and attach front surrounds to
vehicle roll bar starting with the front as shown.
Unzip roll bar covers and secure the other side of the
front surrounds to the B-pillar.
7
8
3/8x2.75
Hex Bolt
3/8 Washer
3/8 Nut
#10x1 Button
Head Bolt
#10 Washer
#10
Flange Nut