Rugged Ridge PowerTop Kit, 07-14 Jeep Wrangler Unlimited (JK), Black - Manual (Page 21)

Section E Page 19
VEHICLE
CONNECTION
TAIL LIGHT
CONNECTION
POWER
TO
P
HARNESS
VEHICLE
CONNECTION
POWER
TOP HARNESS
HITCH
CONNECTION
Owners Without a Towing Wire Harness - Connect power
top electrical harness to vehicle tail light harness by
connecting the male Power Top connector to the female
vehicle connector and connecting the female power top
connector to the male tail light connector. Skip to Step 11.
Re-install the tail light.
Owners With a Towing Wire Harness - Connect power top
electrical harness to vehicle tail light harness by
connecting the male Power Top connector to the female
vehicle connector and connecting the female power top
connector to the male hitch connector.
9
11
10
©2012
2007-2011 Jeep® Owners Only. 2011+ Jeep® Owners skip to Step 8.
Route the tail light portion of the electrical harness underneath the carpet
and through the hole found at the rear and top of the wheel well. Remove
the grommet and pull the cord through to the tail light opening at the rear of
the vehicle.
Owners Without a Towing Wire Harness - Skip to Step 9.
Owners With a Towing Wire Harness - Skip to Step 10.
2011+ Jeep® Owners Only. Remove the plastic cover over
the rear wheel well. Route the tail light portion of the
electrical harness underneath and through the notch that was
cut out in Section C to route the hydraulic hoses. Route the
electrical harness through the hole found at the rear and top
of the wheel well. Remove the grommet and pull the cord
through to the tail light opening at the rear of the vehicle.
Re-install the rear driver side cover over the routed harness.
Owners Without a Towing Wire Harness - Skip to Step 9.
Owners With a Towing Wire Harness - Skip to Step 10.
7
8