Festo Промежуточная позиция для линейного модуля DGC - Manual (Page 20)

SLG−Z−...
Festo SLG−Z−... 0512a English
20
4 Fitting
Fitting mechanical components
Please note
The stop will be damaged if masses strike
it at an angle.
Make sure that the cushioning energy
is always applied vertically, if possible in
the centre of the stop plate
6.
S Screw a connector (see Accessories")
into the connector thread
1.
S Fasten the support holder type SLG−D−...
as follows:
1. Push cushioning elements (shock abĆ
sorbers or rubber buffers) into the
cushioning support.
When retrofitting an existing slide unit
type SLG−... , you can use the shock abĆ
sorbers of the slide unit. Lift these out
with a screwdriver and push them into the
cushioning support (see Fig. 9).
Fig. 7
m
m
Fig. 8
Fig. 9