Kramer Electronics TP-124 - Manual (Page 22)

Connecting the XGA/Audio/Data Line Transmitter/Receiver
19
19
8.1 Wiring the CAT 5 LINE IN/LINE OUT RJ-45 Connectors
Table 12 and Figure 14 define the UTP CAT 5 PINOUT, using a straight
pin to pin cable with RJ-45 connectors:
Table 12: CAT 5 PINOUT Figure 14: CAT 5 PINOUT
EIA /TIA 568A EIA /TIA 568B
PIN Wire Color PIN Wire Color
1 Green/White 1 Orange/White
2 Green 2 Orange
3 Orange/White 3 Green/White
4 Blue 4 Blue
5 Blue/White 5 Blue/White
6 Orange 6 Green
7 Brown/White 7 Brown/White
8 Brown 8 Brown
Pair 1 4 and 5 Pair 1 4 and 5
Pair 2 3 and 6 Pair 2 1 and 2
Pair 3 1 and 2 Pair 3 3 and 6
Pair 4 7 and 8 Pair 4 7 and 8
9 Connecting the XGA/Audio/Data Line
Transmitter/Receiver
You can use the TP-123 XGA/Audio/Data Line Transmitter and the TP-124
XGA/Audio/Data Line Receiver to configure a twisted pair transmitter and
receiver system, to transmit the video, audio and RS-232 control signals via
CAT 5 UTP cable. To connect the TP-123 and the TP-124 to configure a
twisted pair transmitter and receiver system, as the example in Figure 15
illustrates, do the following:
1. On the TP-123, connect:
 An XGA source (for example, a laptop’s graphics card) to the
XGA IN 15-pin HD (F) connector and an audio source to the
Audio IN 3.5mm mini jack, for example, using a Kramer
C-GMA/GMA cable (VGA 15-pin HD (M) +Audio jack to
VGA 15-pin HD (M) +Audio jack) 1
 An RS-232 cable with a 9-pin D-sub connector at one end to the
laptop, and a 2 PIN terminal block connector at the other end to
1 Not supplied. The full list of Kramer cables is on our Web site at http://www.kramerelectronics.com . Alternatively, you can
connect an XGA source to the XGA IN 15-pin HD (F) connector, and a separate audio source to the AUDIO IN 3.5mm mini
jack