Kramer Electronics VP-774AMP - Manual (Page 17)

12 VP-774AMP - Connecting the VP-774AMP
5 Connecting the VP-774AMP
Always switch off the power to each device before connecting it to
your VP-774AMP. After connecting your VP-774AMP, connect its
power and then switch on the power to each device.
You do not have to connect all the inputs and outputs, connect only
those that are required.
To connect the VP-774AMP, as illustrated in the example in Figure 4 , do the
following:
1. Connect an HDMI source (for example, a DVD player) to the HDMI 1 IN
VIDEO INPUT connector.
Alternatively, you can connect the DVI connector on the DVD player to the HDMI
connector on the VP-774AMP via a DVI-HDMI adapter. You can connect the audio
signal via the AUDIO IN HDMI 3.5mm mini jack, or use the embedded audio
2. Connect a computer graphics source to the PC 1 IN VIDEO INPUT 15-pin
HD connector.
Alternatively, you can connect a component (YPbPr) or RGBHV source via the 15-pin
HD connector, see
Figure 3
Figure 3: 15-pin HD Connector Pinout
3. Connect a composite video source (for example, a composite video player)
to the CV 1 IN RCA connector.
4. Connect a DisplayPort video source (for example, a computer graphics
source) to the DP IN connector.
5. Connect the audio input signals to the AUDIO IN connectors (3.5mm mini
jack and RCA connectors), as required (not shown in Figure 4 ).
!
i