Kramer Electronics VP-774AMP - Manual (Page 53)

48 VP-774AMP - The Display Modes
7.2.3 Selecting the PIP Source
To select a PiP source you have to set the VP-774AMP to any of the PiP display
mode configurations and then select the desired input.
7.2.3.1 Selecting the PiP Source via the Front Panel Buttons
Press and hold the PIP front panel button while pressing the input button of the
required PiP source.
For example, to select CV as the PiP source over DP as the main source, press the
PIP front panel button while pressing the CV front panel button (see Figure 32 ).
In this example, the DP button is illuminated and the CV button blinks
Figure 32: CV superimposed over DP
7.2.3.2 Selecting the PiP Source via the IR Remote Control Transmitter
Press the PIP button on the IR transmitter (the PIP front panel button is
illuminated). Press the desired PiP source button on the IR transmitter (see Section
8.4 ).
7.2.3.3 Selecting the PiP Source via the OSD Menu
You can select an input source only after you set the display mode
to one of the PiP configurations (see Section 6.2 ).
i