Kramer Electronics VP-774AMP - Manual (Page 66)

VP-774AMP - Technical Specifications 61
61
11.1 Default Communication Parameters
RS-232
Protocol 3000 (Default) Legacy
Baud Rate: 115,200 9,600
Data Bits: 8 8
Stop Bits: 1 1
Parity: None None
Command Format: ASCII ASCII
Example (Set display mode to Picture in Picture): #Y 0,110,1<CR> >Y 0 110 1<CR>
Ethernet
To reset the IP settings to the factory reset values, power cycle the device while holding in the
Ethernet Reset button, located on the rear panel of the unit
IP Address: 192.168.1.39
Subnet mask: 255.255.000.000
Default gateway: 000.000.000.000
TCP Port #: 5000
UDP Port #: 50000
Maximum UDP Ports: 10
Maximum TCP Ports: 4
Full Factory Reset
Front panel buttons Turn power off. Turn power on again while holding the RESET TO
XGA/720p front panel button. The LEDs blink. Full factory reset is
complete once the LEDs cease to blink and react normally
OSD Factory Reset through the Misc menu item
Protocol 3000 Use “Factory” command or #Y 0,770,1<CR>
11.2 Input Resolutions
This section defines the input resolutions for each input
11.2.1 SDI Input Resolutions
SDI Input Resolution
NTSC 720_P60 1080_P24 1080_P50
PAL 1080_I50 1080_P25 1080_P60
720_P50 1080_I60 1080_P30