Kramer Electronics VS-44HD - Manual (Page 12)

Connecting Your VS-44HD
9
6.2 Connecting the VS-44HD as a Dual-Link 2x2 SD/HD-SDI Matrix
Switcher
You can use your VS-44HD in the dual-link mode to switch either of the two
dual-link SDI inputs, input 1 and 2, or input 3 and 4, to one or both of the two
dual-link SDI outputs, output 1 and 2, and/or output 3 and 4, as the example in
Figure 3 shows.
To connect the
VS-44HD as a dual-link 2x2 SD/HD-SDI Matrix switcher, do
the following 1 :
1. Connect up to two SDI sources to the SDI INPUT BNC connectors (for
example, an HD/SD SDI camera to inputs 1 and 2, and an HD video player
to inputs 3 and 4).
2. Connect the SDI OUTPUT BNC connectors to up to 2 two SDI acceptors
(for example, outputs 1 and 2 to a Preview monitor, and outputs 3 and 4
to an HD SDI mixer).
3. Follow steps 3 to 7 in section 6.1.
4. Set the machine to the dual-link mode, see section 6.3.
1 Switch OFF the power on each device before connecting it to your VS-44HD. After connecting your VS-44HD, switch on
its power and then switch on the power on each device
2 When only one output is required, connect that output, and leave the other outputs unconnected