Kramer Electronics VS-44HD - Manual (Page 20)

Operating the VS-44HD
17
7 Operating the VS-44HD
You can operate your VS-44HD via:
The front panel buttons
RS-232/RS-485 serial commands transmitted by a PC, touch screen
system, or other serial controller
The Kramer infrared remote control transmitter
The ETHERNET
7.1 Switching OUT-IN Combinations
To switch an input to an output via the front panel buttons 1 , in the AT ONCE
mode (see section 7.3), do the following:
1. Press an OUTPUT button (1, 2, 3, 4 or ALL).
The selected OUTPUT button illuminates brightly, as does the 7-segment
display.
2. Press an INPUT button (1, 2, 3, 4 or OFF) 2 .
The selected input switches to the selected output. The digits displayed in
the 7-segment display change as appropriate.
After a few seconds the selected OUTPUT button switches OFF and the
OUTPUT buttons illuminate according to the signal routed to the relevant
output.
Note that:
The OUTPUT button color changes during routing according to the color
of the input button: green (for standard definition) or blue (for high definition)
If an OUTPUT button is not selected, that button will not illuminate
If an OUTPUT is connected to the input with no signal connected, that
OUTPUT button will not illuminate
7.2 Switching OUT-IN Combinations in the Dual-Link Mode
To switch an input to an output in the Dual-Link Mode via the front panel
buttons 1 , in the AT ONCE mode (for immediate switching), do the following:
1. Press an OUTPUT button (either 1, 2 or ALL).
The selected OUTPUT button illuminates brightly, as does the 7-segment
display.
1 For details of how to route an input to an output using the REMOTE connector, see section 6.10
2 For immediate switching