Kramer Electronics VS-44HD - Manual (Page 21)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Operating the VS-44HD
18
2. Press an INPUT button (either 1, 2 or OFF).
The selected input switches to the selected output, and that input button
illuminates brightly. The digits displayed in the 7-segment display change
as appropriate.
7.3 Confirming Settings
Choose to work in the AT ONCE or the CONFIRM mode (see section 7.3.1).
When the VS-44HD operates in the AT ONCE mode, pressing an OUT-IN
combination implements the switch immediately. In the CONFIRM mode,
the TAKE button must be pressed to authorize the switch.
In the AT ONCE mode, you save time as execution is immediate and actions
require no user confirmation. However, no protection is offered against
changing an action in error.
In the CONFIRM mode:
You can key-in several actions and then confirm them by pressing the
“TAKE” button, to simultaneously activate the multiple switches
Every action requires user confirmation, protecting against erroneous
switching
Execution is delayed until the user confirms the action
Note that after ten seconds the VS-44HD will go to standby mode and the
buttons and the 7-segment display will illuminate less brightly
7.3.1 Toggling between the AT ONCE and CONFIRM Modes
To toggle between the AT ONCE and CONFIRM modes, do the following:
1. Press the dim TAKE button to toggle from the AT ONCE mode (in which
the TAKE button is dim) to the CONFIRM mode (in which the TAKE
button illuminates).
Actions now require user confirmation and the TAKE button illuminates.
2. Press the illuminated TAKE button to toggle from the CONFIRM mode
back to the AT ONCE mode.
Actions no longer require user confirmation and the TAKE button no
longer illuminates.
7.3.2 Confirming a Switching Action
To confirm a switching action (in CONFIRM mode- where the TAKE button
is illuminated), do the following:
1. Press an OUT-IN combination.
The 7-segment Display blinks 1 .
1 The timeout lasts for 10 seconds