Kramer Electronics VS-88HC - Manual (Page 12)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Your VS-88HC 8x8 Home Entertainment Matrix Switcher
8
Table 3: Rear Panel VS-88HC 8x8 Home Entertainment Matrix Switcher Features
# Feature Function
1 S/PDIF Connect to the digital audio source (from INPUT 1 to 8)
2 Y RCA Connectors
3 U/Cb/Pb RCA
Connectors
4
IN
P
U
TS
C
om
po
ne
nt
V/Cr/Pr RCA
Connectors
Connect to the component (Y, U/Cb/Pb, V/Cr/Pr) video source
(from INPUT 1 to INPUT 8)
5 S/PDIF Connect to the digital audio acceptor (from OUTPUT 1 to 8)
6 Y RCA Connectors
7 U/Cb/Pb RCA
Connectors
8 O
U
TP
U
TS
C
om
po
ne
nt
V/Cr/Pr RCA
Connectors
Connect to the component (Y, U/Cb/Pb, V/Cr/Pr) video acceptor
(from OUTPUT 1 to 8)
9 RS-232 DB 9F Port Connect to the PC or the Remote Controller via a null-modem
connection
10 RS-485 Terminal Block Port Pins B (-) and A (+) are for RS-485; Pin G may be connected to the
shield (if required)
11 Setup Dipswitches Dipswitches for setup of the unit (1, 2 and 3 are for setting the
Self Address #; and 4 is for RS 485 termination)
12 REMOTE IR 3.5mm Mini Jack Connect to an external IR receiver unit for controlling the machine via
an IR remote controller (instead of using the front panel IR receiver) 1
13 Power Connector with Fuse AC connector enabling power supply to the unit
14 OUT Connect to the digital audio acceptor
15
OPTIONAL OPTICAL
AUDIO ON CHAN. 2
TOSLINK Connector
IN Connect to the digital audio source
16 ETH Factory Reset Button Press to reset to factory default definitions 2 :
IP number 192.168.1.39
Mask – 255.255.255.0
Gateway – 192.168.1.1
17 ETHERNET Connector Connects to the PC or other Serial Controller through computer
networking LAN
18 ETH PROG Button Push in to upgrade ETH firmware (see section 9.2);
release for normal operation
19 FLASH PROG Button Push in 3 for “Program” to upgrade the switcher microcontroller to the
latest Kramer firmware (see section 9.1.2), or release (the factory
default) for normal operation
20 LEFT Connect to the left audio acceptor (from OUTPUT 1 to 8)
21
OUTPUTS
RIGHT Connect to the right audio acceptor (from OUTPUT 1 to 8)
22 LEFT Connect to the left audio source
23
A
N
A
LO
G
A
U
D
IO
INPUTS
RIGHT Connect to the right audio source
1 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the VS-88HC (only if the internal
IR connection cable has been installed)
2 First disconnect the power cord and then connect it again while pressing the ETH Factory Reset button. The unit will power
up and load its memory with the factory default definitions
3 Using a screwdriver if required