Sunlight Supply Quest Dual 110 Overhead Dehumidifier - Manual (Page 5)

1-800-533-7533
Quest 110 Dual Installation, Operation and Maintenance Instructions
5
www.QuestProtect.com
[email protected]
quest
Asset Protection and IAQ Solutions
quest
4. Installation
CAUTION! Remove compressor shipping tie from the unit. Failure to remove
shipping tie will cause excess vibration to be transmitted to the frame.
4.1 Remove Compressor Shipping Support
The Quest 110 Dual uses a compressor to power the refrigeration system. To protect the
compressor and refrigeration system during shipping a plastic tie wrap secures it to the
units frame. Remove the tie wrap by cutting the tie wrap and pulling from the unit as
shown. After removing tie wrap, insert plastic plugs provided into the holes.
4.2 Location
The Quest 110 Dual can be installed in a variety of locations to meet the owner’s needs; other considerations
include:
1. Providing access to a 115 VAC power outlet (10’ power cord is provided).
2. Locating near a floor or other suitable drain.
3. Mount 4” above drain.
4. Do not install the Quest 110 Dual with the exhaust of the unit within 1’ of a wall or obstruction. Do not
place the unit near open water.
4.2A No Ducting (fig. 1)
The simplest installation is to place the Quest 110 Dual with no ducting. To ensure optimal performance, the
air inlet and the outlet of the unit must be at least 1’ from walls and other obstructions to air flow.
Input of
Humid Air
Output of
Dehumidified Air
Front View
Figure 1: Installation with no ducting.