WIKA IUT-11 - Manual (Page 33)

22
669
39
.0
5 D
/G
B
06
/2
00
6
Universal IS Pressure Transmitter UniTrans
Installation
Subject to change due to technical modifications. © Copyright WIKA Alexander Wiegand GmbH & Co. KG / Germany
WIKA Alexander Wiegand GmbH & Co. KG · Alexander-Wiegand-Str. · 63911 Klingenberg · (09372) 132 - 710 · Fax - 706 · E-mail: [email protected] · www.wika.de
108
7 Installation
The device should be installed/operated in accordance with the regulations of ElexV,
the Device Safety Regulation, this operating manual and generally recognized
industry standards.
7.1 Pressure Transmitter Installation
Installation Using a Weld-on Adapter:
• Insert a filler piece (a pressure transmitter dummy) into the weld-on adapter.
• Weld the adapter into the container/pipe wall (section-weld process).
• Remove the filler piece.
• Install the pressure transmitter in the weld-on adapter.
7.2 Display Unit Upgrades
The display unit can be easily upgraded at any time.
• Remove the housing cover and the supporting string.
• Attach the display unit’s supporting string to the same place.
• Plug the display unit’s connector into the appropriate jack.
• The display unit can be mounted at 90° angles.
• Fasten the display unit with screws.
Before mounting the transmitter make sure to read the operating manual,
as well as the EC-type examination certificate.
The pressure transmitter’s diaphram should not come into contact with
hard or sharp objects.
When installing the display unit, make sure that the connection cable
and the supporting string are not kinked or pinched. If the cable is
damaged, correct function may be impaired..
On Model IUT the Ex-protection of the transmitter will no longer exist.
Only the model A-IRU can be mounted as display for upgrading .
Warning
Warning
Warning