Norgren 200 Series Nugget Spool Valves - Manual (Page 35)

Nugget 200 Spool Valves
Littleton, CO USA Phone: 303-794-2611 www.norgren.com VAL-10-35
Special Instructions – Stacking Valves
● The numbers shown in the stacking valve Ordering Information
tables include the valve plus the interface seals and threaded tie
rods needed to connect the valve to the adjacent valve or end
plate.
● An end plate kit is required to complete a valve stack assembly.
It includes two end plates and the necessary seals and attaching
hardware. Also included are three pipe plugs to close one end of
the stack and three isolating plugs (discs). The isolating plugs
can be used to separate the valve stack into two sections and
thus allow valves with a common inlet only to be combined with
valves having both a common inlet and common exhausts, or to
allow the use of different inlet pressures.
● Always specify the valve order number, the end plate kit number
and the quantity desired. See table below.
● Valves and end plates are shipped unassembled. See pp.
VAL-10-36/37 for factory assembled stacks.
● Stacking valves are available in two configurations – Common
Inlet and Exhaust (Ports 1, 3, and 5) and Common Inlet Only
(Port 1). Speed controls can be installed in the exhaust ports
only on the Common Inlet (Port 1) configuration. The Common
Inlet (Port 1) configuration cannot be used with the junction box.
● Solenoid operated 2-position detent and nondetent, and 3-
position spring centered valves can be combined in the same
stack.
Isolating Plugs
O-Ring
Pipe
Plug End Plate
End Plate
Tie Rod
Isolating Plugs
O-Rings
End Plate
End Plate
Tie Rod
Typical Valve Stack (Common Inlet Only - Port1)
Typical Valve Stack (Common Inlet and Exhaust - Ports 1, 3 and 5)
Order Number
3/8 PTF G 3/8 ISO
End Plate Kit Ports Ports
For valves without
junction box
13295-52 13295-53
For valves with
junction box
13295-50 13295-51
Quantity
Isolating Plugs Required Order No.
Inlet (Port 1) 1 54350-89
Exhaust (Ports 3 & 5) 2 54350-88
Isolating Plugs
Stacked banks of valves can be divided into
two sections by substituting the isolating plugs
for the O-rings between any two valves. They
can also be used to block the end plate ports
on one end if desired. Although one inlet port
and two exhaust port isolating plugs are
included with the end plate kit, the individual
plugs can be ordered separately.