Revolabs Solo Executive Operation Manual - Manual (Page 12)

- 9 -
There are four or eight output channels representing a separate channel for
each microphone. Accordingly, there are four or eight input channels to the
unit. The microphone output connectors need to be attached to the line-level
(0dBu) input connectors of an audio mixer. PHANTOM POWER MUST BE OFF.
The Base Station input connectors (also 0dBu) may then be attached to mixer
channel outputs. Because the system is full-duplex, the input connections
provide the ability to hear program audio using a 2.5mm earpiece attached to
the microphone (supplied with the wearable microphone).
Depending on the application, it is possible to feed a single mixed channel back
to all earpieces or, alternatively, each user can receive a separate and unique
channel. This would allow for translation, personal hearing assistance or other
services to be incorporated into an application.
Setting up the Solo Executive
The Base Station has four or eight indicator LEDs (one for each channel) and
pairing push buttons on the front panel. When the LED is flashing GREEN or
RED, that channel is active and connected to a wireless microphone (GREEN is
for live audio, RED is for muted). When the LED is OFF, the channel is inactive
(the microphone is out of range or turned off).
The front panel also has one or two sets of diversity antennas for optimal
reception, and a smaller antenna for System Mute reception. These antennas
are removable for relocation by installation professionals, based on the
installation environment and coverage optimization requirements.
Linking the Charger Base with the Base Station
Linking (like pairing) is used to create a link between the Charger Base System
Mute control and the Base Station. When the Charger Base and Base Station
are linked, the system may be muted by pressing the single button.
The Charger Base in new systems is already linked with the Base Station.
However, if a new Charger Base is ever required, it will need to be manually
linked with the Base Station.
To link the Charger Base with the Base Station:
1. Power-on the Charger Base and Base Station (power LEDs on both units will
display GREEN).
2. Place the Base Station system into learning mode by briefly pressing the
LEARN button on the rear connection panel. The LED next to the LEARN
button will illuminate.