Revolabs Solo Executive Operation Manual - Manual (Page 26)

- 23 -
Appendix A – Adjusting Base Station Power Level
Important: Adjusting RF power settings as described below should only be
performed by trained and authorized audiovisual personnel.
All Revolabs Solo™ products contain MaxFlex™ technology, enabling multiple
systems with a variety of microphone types to be deployed within the same
building.
One of the main features of our products that allow multiple units to coexist in
a building area, without interference is the ability to lower the RF broadcast
power of Executive Base Stations.
Solo Executive Base Stations are normally delivered from the factory configured
for high power mode, which is appropriate for most installations. High power
mode equates to the specified usable microphone range of 100 feet (30M) for
the multi-channel Executive system or 65 feet (20M) for the single channel
system.
If a Solo Executive system needs to operate within the radius of another
system, it is usually advisable to set all the systems to reduced power levels to
preclude systems from interfering with each other. Interference between
systems may cause occasional audio noise and signal dropouts on affected
channels.
A Solo Executive multi-channel system has two lesser power settings available
that deliver usable microphone ranges of 30 feet (power level 2) and 8 feet
(power level 3). A Solo Single Channel system also has two lesser power
settings delivering usable microphone ranges of 20 feet (power level 2) and 6
feet at power level 3.
In performing the following process, it may help to understand that an 8-
channel Executive base station rack unit has four radio transceivers - each
associated with a pair of audio channels - and that each transceiver needs to
be configured separately.
Similarly, a 4-channel Executive base station rack unit has two radio
transceivers, while a single channel system has just one transceiver in the
charging Base Station.
To configure a multi-channel Solo Executive base station for reduced power
level modes:
1. Power-off base station at the power switch on the back of the unit
2. Press and hold the CHANNEL 2 button and power-on the unit